# Is 12.4 Volts OK Car Battery?

It should be somewhere between 12.8 volts (fully charged) and 12.1 volts (50 percent charged). The battery is not charged, and could be bad, if the reading is 11.9 volts or lower.

## What is the value of voltage when the battery is fully charged?

When, at a charge voltage of 2.45 ± 0.05 volts/cell, the current accepted by the battery drops to less than 0.01 x C amps (1% of rated capacity), the battery is fully charged and the charger should be disconnected or switched to a float voltage of 2.25 to 2.30 volts/cell.

## How many volts should a fully charged 12V battery have?

12.6V volts or above – Your battery is healthy and fully charged. No further action is required. 12.5 volts – Your battery is at a healthy state of charge, but we’d recommend re-checking it within a few days to ensure the voltage hasn’t dropped any further.

### Is 11.9 volts enough to start a car?

When the probes touch the terminals while the car is off and the battery is resting, the multimeter display should show a reading of 12.2 to 12.6 volts (full charge). This voltage range means the battery is in good condition for starting the vehicle.

### What should a 12-volt battery read on a voltmeter?

A fully charged battery will typically display a voltmeter reading of about 12.6 to 12.8 volts. If your voltmeter is showing a voltage anywhere between 12.4 and 12.8, that means your battery is in good shape. Any voltage above 12.9 volts is a good indicator that your battery has excessive voltage.

### Can you overcharge a 12V battery?

A 12V lead-acid battery won’t be damaged by overcharging if the voltage is kept low and the charging current is less than the Ah capacity. … The battery may become overheated if it can put out more current than it can take.

### Is 14 volts good for a car battery?

It should read close to 12.6 volts when the car is off. … If the voltmeter reads between 14-15 volts then the battery is normal. But if the battery reads over 15 volts or less than 13 volts, then there might be a problem with the voltage regulator, the wiring or the alternator.

### How many volts does a car battery need to start?

The normal voltage needed to start the car begins from 12.6 volts. At the time of exploitation, this parameter is between 13.7 to 14.7 volts.

### How many amps are in a 12-volt car battery?

Car batteries will typically have a capacity of 48 amp hours. What this means is a fully-charged 12-volt car battery rated at 48 amp hours can deliver 1 amp for 48 hours or 2 amps for 24 hours. This also means the battery can supply 8 amps for 6 hours under ideal operating conditions.

### Can you leave a battery charger on overnight?

Even though there is no risk of overcharging with the use of a high quality charger, the battery should not remain connected to the charger for more than 24 hours. A full charge is usually achieved by charging overnight.

### What happens if you leave a battery charger on too long?

A: If you leave the charger connected continuously, even at a mere 2 amps, the battery eventually will die. Overcharging a battery causes excessive gassing — the electrolyte gets hot and both hydrogen and oxygen gas are generated. … On sealed batteries, the buildup of gases could cause the battery to burst.

### Can you overcharge a battery with a trickle charger?

Can you overcharge a car battery with a trickle charger? Yes. A trickle charger provides a low current to the battery for slow charging. If it does not have a built-in automatic cutoff, it will continue to provide the current even when the battery is fully charged.

### Can you test a 12-volt battery with multimeter?

A 12-volt battery is the kind of battery you’d find often used on motorcycles and other vehicles, and you can use a voltmeter to test this system. You can also use a multimeter to test your 12 volt battery. A multimeter can measure voltage, but that’s only one of its functions.

### How many volts should a battery drop overnight?

If you measure the voltage immediately after the end of a drive, it should be more like 13.2, and drop to 12.7 within a few minutes as the chemical reactions in the battery slow down and stop when you stop charging it.

### What voltage indicates a bad battery?

If your battery is reading 0 volts, chances are the battery experienced a short circuit. If the battery cannot reach higher than 10.5 volts when being charged, then the battery has a dead cell. If the battery is fully charged (according to the battery charger) but the voltage is 12.5 or less, the battery is sulfated.

### What voltage is too low for car battery?

A fully charged battery should read over 12.6 volts. If the battery reads 12.45 volts or less, it is low (less than 75 percent charged) and needs to be recharged.

### What should a 12 volt leisure battery read when fully charged?

The reading should be between 1.1 (discharged) and 1.28 (fully charged). To determine how long the battery can go between charges, check the capacity, which is normally measured in amp hours (Ah).

### What should a 12 volt deep cycle battery read when fully charged?

Voltage on a fully charged battery will read 2.12 to 2.15 volts per cell, or 12.7 volts for a 12 volt battery. At 50% the reading will be 2.03 VPC (Volts Per Cell), and at 0% will be 1.75 VPC or less.

### How do you discharge a 12 volt battery?

Specifically, if you want to fully discharge a typical car battery (12V, 60 A hr), all you need is a 20 ohm, 10 W resistor (or equivalent), and connect it across the battery terminals. Leave it connected for about 4 days, and with a voltmeter verify that the voltage is zero.

### Is it better to charge a battery at 2 amps or 10 amps?

Consequently, when trying to charge a larger battery at that rate, it will take a very long time and the battery may discharge at a greater rate than the 2-amp charge can provide. It is better to charge a deep cycle battery at a higher charge rate like 6-amps, 10-amps or higher.